Electromechanical door release (electric strike) mortise and surface-mounted
Country: · Model: REF. 29588
Electromechanical door releases open entrance doors and gates remotely on a command from a video door entry monitor, a call panel with a code keypad or an access controller. Mortise and surface-mounted versions are available, and the SEE-U call panel output to the lock is rated 12 V DC at a current of up to 250 mA.
- Versions
- mortise (flush) and surface-mounted (surface)
- Accessories
- mounting parts
Technical specifications
| Versions | mortise (flush) and surface-mounted (surface) |
|---|---|
| Accessories | mounting parts |
Specifications are taken from the manufacturer’s technical documentation. Updated .
Description
The release is installed in the door frame opposite the bolt of the mechanical lock. When voltage is applied, it frees the bolt and the door opens with a push. In the catalogue the releases are divided into three groups. Mortise (flush) ones are installed so that the corresponding part of the lock sits flush in the frame, surface-mounted (surface) ones are mounted on the surface of the door or frame, and accessories complete the installation. The documentation for SEE-U kits states that the call panel output is rated 12 V DC at a continuous current of up to 250 mA, and a low-consumption DC release REF. 29588 is recommended for it. For a gate drive a separate potential-free relay contact is used. The releases are installed on entrance doors of apartment buildings and offices, on gates of private houses and on doors with a door entry system or access control system. The supply voltage, the fail-safe and fail-secure modes and the holding force are not published on the section page. The manufacturer was founded in 1949 in Valencia, has two factories of its own, ISO 9001 processes, and supplies products to more than 85 countries.
How to choose
The choice between a mortise and a surface-mounted release depends on where the lock is fixed, in the frame or on the surface. The main parameter for selection is the current, because the SEE-U panel output gives 12 V DC up to 250 mA, so the release must be low-consumption, as in the example REF. 29588, and the gate is controlled by a separate relay contact. Check the supply and the fail-safe or fail-secure mode in the technical sheet of the article, and for the subscriber part look at SEE-U with a 7″ monitor.
Request a price and lead time
Electromechanical door release (electric strike) mortise and surface-mounted. We reply within one business day.
Or email office@usk.ua or call +38 (044) 339-50-20.
FAQ
What voltage and current does the call panel output to the electric lock have?
According to the documentation for SEE-U kits it is 12 V DC at a continuous current of up to 250 mA.
Which release is recommended for the SEE-U call panel?
The low-consumption DC release REF. 29588.
How does a mortise release differ from a surface-mounted one?
A mortise one is installed so that the corresponding part of the lock is flush in the frame, and a surface-mounted one is mounted on the surface of the door or frame.
How is a gate drive controlled?
A separate potential-free relay contact is used for gates, not the output to the electric lock.
Which release parameters should be clarified before ordering?
The supply voltage, the fail-safe or fail-secure mode and the holding force, because they are not published on the section page.
REQUEST
Need a price, lead time or replacement?
Send us a request and we will confirm the configuration, lead time and delivery terms. We reply by email.